Miura MB-101 vs Miura KM-700

Side-by-side factory specifications. Differing values are highlighted.

Specification comparison

ClubMB-101 loftKM-700 loftMB-101 lieKM-700 lieMB-101 lengthKM-700 length
321—60.5—39—
42423616138.538.5
5272661.561.53838
63029626237.537.5
7343362.562.53737
83837636336.536.5
9424163.563.53636
PW4746646435.7535.75

Highlighted cells differ between the two sets. Lofts and lies are factory standard.

Lofts compared

  • MB-101
  • KM-700
MB-101 and KM-700 lofts comparedLine chart of loft in degrees by club for the MB-101 and the KM-700. 3: 21 and none. 4: 24 and 23. 5: 27 and 26. 6: 30 and 29. 7: 34 and 33. 8: 38 and 37. 9: 42 and 41. PW: 47 and 46.20°30°40°50°3456789PWMB-101 3: 21°MB-101 4: 24°MB-101 5: 27°MB-101 6: 30°MB-101 7: 34°MB-101 8: 38°MB-101 9: 42°MB-101 PW: 47°KM-700 4: 23°KM-700 5: 26°KM-700 6: 29°KM-700 7: 33°KM-700 8: 37°KM-700 9: 41°KM-700 PW: 46°Loft
Lofts differ on 7 of the 7 clubs the two sets share. A lower point is a stronger loft.

What the differences mean

At the 7-iron, the MB-101 is 34° and the KM-700 is 33°, a 1° gap. Each degree of loft is worth roughly 3 to 4 yards of carry at the same swing speed, so the KM-700 should carry roughly 3 to 4 yards further with that club, on a slightly lower, shallower flight than the MB-101. Across the 7 clubs both sets share, the KM-700 averages 1° stronger, with the largest gap at the 4-iron (24° vs 23°). The pitching wedges are 47° and 46°; the stronger one leaves a 4° jump to a 50° gap wedge, which matters when planning wedge gapping.

The sets are built differently: the MB-101 runs 3-iron to PW (8 clubs), the KM-700 4-iron to PW (7 clubs).

The MB-101 is a blade iron and the KM-700 a players iron, so they sit one step apart on the forgiveness scale. The KM-700 is the more forgiving design, with a wider sole, more offset and more perimeter weighting for roughly scratch to 10 handicaps. The MB-101 trades some of that for a more compact head, thinner topline and more control over flight and shape, which suits low single-digit handicaps who strike the ball consistently.

The MB-101 is listed as forged muscle-back blade and the KM-700 as forged compact cavity with toe-cut sole grind. The MB-101's muscle-back shape keeps mass directly behind the strike for feedback and control, where a cavity spreads it to the perimeter for forgiveness.

The KM-700 came out 3 years after the MB-101, but it is a different line rather than a direct replacement, so the two were designed for different golfers as well as different seasons.

Which should you choose?

The KM-700 is the stronger-lofted set — up to 1° stronger than the MB-101 on matching clubs. Expect longer carry per numbered iron but a flatter descent angle; gapping at the wedge end is where that shows up.

Both charts are reproduced in full on their own pages: Miura MB-101 specs and Miura KM-700 specs.

Frequently asked questions

Is the Miura MB-101 stronger lofted than the KM-700?

No. The KM-700 is the stronger-lofted set: its 7-iron is 33° against 34° for the Miura MB-101, 1° stronger and worth roughly 3 to 4 yards of extra carry.

What is the loft difference between the Miura MB-101 and KM-700?

At the 7-iron the difference is 1° (34° vs 33°). The largest gap on a shared club is 1° at the 4-iron, and all 7 shared clubs differ.

Which is better for higher handicap golfers, the Miura MB-101 or the KM-700?

The KM-700. As a players iron it is the more forgiving design, suited to roughly scratch to 10 handicaps. The Miura MB-101 is a blade iron, better suited to low single-digit handicaps who strike the ball consistently.

Do the Miura MB-101 and KM-700 have the same lie and length?

At the 7-iron, yes: both are 62.5° lie and 37 inches long.

Shop both models

Compare prices for new and used sets on eBay:

We may earn a commission from purchases made through links on this page at no extra cost to you.