Mizuno MP-29 vs Mizuno MP-30

Side-by-side factory specifications. Differing values are highlighted.

Specification comparison

ClubMP-29 loftMP-30 loftMP-29 lieMP-30 lieMP-29 lengthMP-30 length
115—55—39.75—
218185657.539.2539.25
32121575838.7538.75
424245858.538.2538.25
52727595937.7537.75
63131606037.2537.25
7353560.56136.7536.75
83939616236.2536.25
9434361.562.53635.75
PW4847626335.7535.25
SW56—63—35.5—

Highlighted cells differ between the two sets. Lofts and lies are factory standard.

Lofts compared

  • MP-29
  • MP-30
MP-29 and MP-30 lofts comparedLine chart of loft in degrees by club for the MP-29 and the MP-30. 1: 15 and none. 2: 18 and 18. 3: 21 and 21. 4: 24 and 24. 5: 27 and 27. 6: 31 and 31. 7: 35 and 35. 8: 39 and 39. 9: 43 and 43. PW: 48 and 47. SW: 56 and none.10°20°30°40°50°60°123456789PWSWMP-29 1: 15°MP-29 2: 18°MP-29 3: 21°MP-29 4: 24°MP-29 5: 27°MP-29 6: 31°MP-29 7: 35°MP-29 8: 39°MP-29 9: 43°MP-29 PW: 48°MP-29 SW: 56°MP-30 2: 18°MP-30 3: 21°MP-30 4: 24°MP-30 5: 27°MP-30 6: 31°MP-30 7: 35°MP-30 8: 39°MP-30 9: 43°MP-30 PW: 47°Loft
Lofts differ on 1 of the 9 clubs the two sets share. A lower point is a stronger loft.

What the differences mean

At the 7-iron, the MP-29 is 35° and the MP-30 is 35°, identical at the club most golfers compare on, although other clubs in the sets differ. Across the 9 clubs both sets share, the differences roughly cancel out, with the largest gap at the PW (48° vs 47°). The pitching wedges are 48° and 47°; the stronger one leaves a 3° jump to a 50° gap wedge, which matters when planning wedge gapping. Beyond loft, the MP-29 7-iron sits 0.5° flatter (60.5° vs 61°), which nudges start direction slightly right for a right-hander.

The sets are built differently: the MP-29 runs 1-iron to SW (11 clubs), the MP-30 2-iron to PW (9 clubs).

Both are blade irons, built for low single-digit handicaps who strike the ball consistently. Compact muscleback irons with minimal offset, thin toplines and the smallest sweet spot — built for shot-shaping over forgiveness. Because they target the same golfer, the decision comes down to the specific loft, feel and shaping differences rather than who the sets are made for.

Both heads are listed as forged. With the build method this similar, differences in feel come down to head size, sole width, topline and offset rather than how the heads are made.

There are 11 years between these sets (1992 and 2003), more than one design generation. Over that time irons moved toward stronger lofts, thinner and faster faces, hollow and multi-material heads and wider use of tungsten, so the newer set is not simply a better version of the older one: it may launch and spin quite differently.

Which should you choose?

The MP-30 is the stronger-lofted set — up to 1° stronger than the MP-29 on matching clubs. Expect longer carry per numbered iron but a flatter descent angle; gapping at the wedge end is where that shows up.

Both charts are reproduced in full on their own pages: Mizuno MP-29 specs and Mizuno MP-30 specs.

Frequently asked questions

Is the Mizuno MP-29 stronger lofted than the MP-30?

Not at the 7-iron, where both are 35°. Other clubs in the sets differ, so compare the full table above.

What is the loft difference between the Mizuno MP-29 and MP-30?

At the 7-iron the difference is 0° (35° vs 35°). The largest gap on a shared club is 1° at the PW, and 1 of the 9 shared clubs differ.

Are the Mizuno MP-29 and MP-30 aimed at the same golfer?

Yes. Both are blade irons, built for low single-digit handicaps who strike the ball consistently. Choose on feel, looks and gapping, ideally after hitting both.

Do the Mizuno MP-29 and MP-30 have the same lie and length?

Not exactly. At the 7-iron the Mizuno MP-29 is 60.5° lie and 36.75 inches, the MP-30 61° and 36.75 inches. Both can be bent or built to your own fit.

Shop Mizuno MP-29

Compare prices for new and used sets on eBay:

We may earn a commission from purchases made through links on this page at no extra cost to you.