TaylorMade P770 vs TaylorMade P7MC

Side-by-side factory specifications. Differing values are highlighted.

Specification comparison

ClubP770 loftP7MC loftP770 lieP7MC lieP770 lengthP7MC length
319.52060.560.53939
422.523616138.538.5
525.52661.561.53838
62930626237.537.5
7333462.562.53737
83738636336.536.5
941.542.563.563.53636
PW4647646435.7535.75
AW51—64—35.5—

Highlighted cells differ between the two sets. Lofts and lies are factory standard.

Lofts compared

  • P770
  • P7MC
P770 and P7MC lofts comparedLine chart of loft in degrees by club for the P770 and the P7MC. 3: 19.5 and 20. 4: 22.5 and 23. 5: 25.5 and 26. 6: 29 and 30. 7: 33 and 34. 8: 37 and 38. 9: 41.5 and 42.5. PW: 46 and 47. AW: 51 and none.10°20°30°40°50°60°3456789PWAWP770 3: 19.5°P770 4: 22.5°P770 5: 25.5°P770 6: 29°P770 7: 33°P770 8: 37°P770 9: 41.5°P770 PW: 46°P770 AW: 51°P7MC 3: 20°P7MC 4: 23°P7MC 5: 26°P7MC 6: 30°P7MC 7: 34°P7MC 8: 38°P7MC 9: 42.5°P7MC PW: 47°Loft
Lofts differ on 8 of the 8 clubs the two sets share. A lower point is a stronger loft.

What the differences mean

At the 7-iron, the P770 is 33° and the P7MC is 34°, a 1° gap. Each degree of loft is worth roughly 3 to 4 yards of carry at the same swing speed, so the P770 should carry roughly 3 to 4 yards further with that club, on a slightly lower, shallower flight than the P7MC. Across the 8 clubs both sets share, the P7MC averages 0.8° weaker, with the largest gap at the 6-iron (29° vs 30°). The pitching wedges are 46° and 47°; the stronger one leaves a 4° jump to a 50° gap wedge, which matters when planning wedge gapping.

The sets are built differently: the P770 runs 3-iron to AW (9 clubs), the P7MC 3-iron to PW (8 clubs).

Both are players irons, built for roughly scratch to 10 handicaps. Small-to-mid cavity backs with traditional lofts, modest offset and workable shaping for low-handicap players. Because they target the same golfer, the decision comes down to the specific loft, feel and shaping differences rather than who the sets are made for.

The P770 is listed as forged hollow body and the P7MC as forged. The P770's hollow body lets the face flex more and moves mass low and outward, usually giving higher launch and more ball speed on off-centre strikes than the P7MC, at some cost in feel.

Both sets were introduced in 2020, so this is a choice between two models from the same lineup rather than an upgrade: TaylorMade designed them to sit side by side for different players.

Which should you choose?

The P7MC is the weaker-lofted set — up to 1° weaker than the P770. That trades raw distance for a steeper landing angle and more predictable stopping power into greens.

Both charts are reproduced in full on their own pages: TaylorMade P770 specs and TaylorMade P7MC specs.

Frequently asked questions

Is the TaylorMade P770 stronger lofted than the P7MC?

Yes. The TaylorMade P770 7-iron is 33° against 34° for the P7MC, 1° stronger, which is worth roughly 3 to 4 yards of extra carry with the same swing.

What is the loft difference between the TaylorMade P770 and P7MC?

At the 7-iron the difference is 1° (33° vs 34°). The largest gap on a shared club is 1° at the 6-iron, and all 8 shared clubs differ.

Are the TaylorMade P770 and P7MC aimed at the same golfer?

Yes. Both are players irons, built for roughly scratch to 10 handicaps. Choose on feel, looks and gapping, ideally after hitting both.

Do the TaylorMade P770 and P7MC have the same lie and length?

At the 7-iron, yes: both are 62.5° lie and 37 inches long.

Shop TaylorMade P770

Compare prices for new and used sets on eBay:

We may earn a commission from purchases made through links on this page at no extra cost to you.