Specification comparison

Highlighted cells differ between the two sets. Lofts and lies are factory standard.

Lofts compared

What the differences mean

At the 7-iron, the P760 is 33° and the P7MC is 34°, a 1° gap. Each degree of loft is worth roughly 3 to 4 yards of carry at the same swing speed, so the P760 should carry roughly 3 to 4 yards further with that club, on a slightly lower, shallower flight than the P7MC. Across the 8 clubs both sets share, the P7MC averages 0.9° weaker, with the largest gap at the 4-iron (22° vs 23°). The pitching wedges are 46° and 47°; the stronger one leaves a 4° jump to a 50° gap wedge, which matters when planning wedge gapping.

The sets are built differently: the P760 runs 3-iron to AW (9 clubs), the P7MC 3-iron to PW (8 clubs).

Both are players irons, built for roughly scratch to 10 handicaps. Small-to-mid cavity backs with traditional lofts, modest offset and workable shaping for low-handicap players. Because they target the same golfer, the decision comes down to the specific loft, feel and shaping differences rather than who the sets are made for.

The P760 is listed as forged multi-material, hollow in the long irons and the P7MC as forged. The P760's hollow body lets the face flex more and moves mass low and outward, usually giving higher launch and more ball speed on off-centre strikes than the P7MC, at some cost in feel. The P760 adds tungsten weighting, which lowers the centre of gravity and raises stability on mis-hits, helping the long irons launch.

The P7MC came out 2 years after the P760, but it is a different line rather than a direct replacement, so the two were designed for different golfers as well as different seasons.

Which should you choose?

The P7MC is the weaker-lofted set — up to 1° weaker than the P760. That trades raw distance for a steeper landing angle and more predictable stopping power into greens.

Both charts are reproduced in full on their own pages: TaylorMade P760 specs and TaylorMade P7MC specs.

Frequently asked questions