Titleist 710 AP2 vs Titleist 714 AP2
Side-by-side factory specifications. Differing values are highlighted.
Specification comparison
| Club | 710 AP2 loft | 714 AP2 loft | 710 AP2 lie | 714 AP2 lie | 710 AP2 length | 714 AP2 length |
|---|---|---|---|---|---|---|
| 3 | 21 | 21 | 60 | 60 | 39 | 39 |
| 4 | 24 | 24 | 61 | 61 | 38.5 | 38.5 |
| 5 | 27 | 27 | 62 | 62 | 38 | 38 |
| 6 | 31 | 30 | 62.5 | 62.5 | 37.5 | 37.5 |
| 7 | 35 | 34 | 63 | 63 | 37 | 37 |
| 8 | 39 | 38 | 63.5 | 63.5 | 36.5 | 36.5 |
| 9 | 43 | 42 | 64 | 64 | 36 | 36 |
| PW | 47 | 46 | 64 | 64 | 35.75 | 35.75 |
| W | — | 50 | — | 64 | — | 35.5 |
| GW | 51 | — | 64 | — | 35.5 | — |
Highlighted cells differ between the two sets. Lofts and lies are factory standard.
Lofts compared
- 710 AP2
- 714 AP2
What the differences mean
At the 7-iron, the 710 AP2 is 35° and the 714 AP2 is 34°, a 1° gap. Each degree of loft is worth roughly 3 to 4 yards of carry at the same swing speed, so the 714 AP2 should carry roughly 3 to 4 yards further with that club, on a slightly lower, shallower flight than the 710 AP2. Across the 8 clubs both sets share, the 714 AP2 averages 0.6° stronger, with the largest gap at the 6-iron (31° vs 30°). The pitching wedges are 47° and 46°; the stronger one leaves a 4° jump to a 50° gap wedge, which matters when planning wedge gapping.
The sets are built differently: the 710 AP2 runs 3-iron to GW (9 clubs), the 714 AP2 3-iron to W (9 clubs).
Both are players irons, built for roughly scratch to 10 handicaps. Small-to-mid cavity backs with traditional lofts, modest offset and workable shaping for low-handicap players. Because they target the same golfer, the decision comes down to the specific loft, feel and shaping differences rather than who the sets are made for.
Both heads are listed as forged, multi-material dual cavity. Both use tungsten weighting to lower the centre of gravity and steady the head on off-centre strikes.
There are 4 years between these sets (2009 and 2013), more than one design generation. Over that time irons moved toward stronger lofts, thinner and faster faces, hollow and multi-material heads and wider use of tungsten, so the newer set is not simply a better version of the older one: it may launch and spin quite differently. Here the 7-iron loft moved from 35° to 34°.
Which should you choose?
The 714 AP2 is the stronger-lofted set — up to 1° stronger than the 710 AP2 on matching clubs. Expect longer carry per numbered iron but a flatter descent angle; gapping at the wedge end is where that shows up.
Both charts are reproduced in full on their own pages: Titleist 710 AP2 specs and Titleist 714 AP2 specs.
Frequently asked questions
Is the Titleist 710 AP2 stronger lofted than the 714 AP2?
No. The 714 AP2 is the stronger-lofted set: its 7-iron is 34° against 35° for the Titleist 710 AP2, 1° stronger and worth roughly 3 to 4 yards of extra carry.
What is the loft difference between the Titleist 710 AP2 and 714 AP2?
At the 7-iron the difference is 1° (35° vs 34°). The largest gap on a shared club is 1° at the 6-iron, and 5 of the 8 shared clubs differ.
Are the Titleist 710 AP2 and 714 AP2 aimed at the same golfer?
Yes. Both are players irons, built for roughly scratch to 10 handicaps. Choose on feel, looks and gapping, ideally after hitting both.
Do the Titleist 710 AP2 and 714 AP2 have the same lie and length?
At the 7-iron, yes: both are 63° lie and 37 inches long.
Shop Titleist 710 AP2
Compare prices for new and used sets on eBay:
We may earn a commission from purchases made through links on this page at no extra cost to you.