Callaway Big Bertha (2004) Irons Specifications

Full factory loft, lie and length chart for the Callaway Big Bertha (2004) irons, 2004–2006.

Years produced
2004–2006
Category
Game Improvement Irons
Construction
investment cast
Material
stainless steel
Set makeup
2–LW

Data confidence: medium. These figures are compiled from secondary sources rather than a manufacturer spec sheet. If you have an original catalogue page, send it over and we will update the chart.

Loft, lie & length chart

Standard men's steel-shaft specifications for the Callaway Big Bertha (2004) irons.
ClubLoft (°)Lie (°)Length (in)BounceSwing wt
21759.239.50D2
32059.9390.5D2
42360.638.50.5D2
52661.3381D2
6296237.51D2
73362.5372D2
83763.536.53D2
94164.5365D2
PW456535.757D3
AW506535.57D4
SW556535.2512D5
LW6065359D5

Lofts and lies are the factory standard build. Individual clubs may differ if they have been bent, re-shafted or re-gripped during their life.

About the Callaway Big Bertha (2004)

The 2004 Big Bertha irons replaced the 2002 set and softened the ladder by a degree at every club — a 33 degree 7-iron against 34 and a 45 degree pitching wedge against 46 — while keeping the upright 65 degree wedge lies and the 35.75 inch pitching wedge of the 2002 model. Every iron head has the same wide sole width to keep the centre of gravity low and deep across the set. The catalogued range ran 2-iron to lob wedge including a 50 degree W wedge, recorded here as AW, and the recorded swing weights are the steel build with graphite two to three points lighter.

Stock shafts

Related models

Frequently asked questions

What is the loft of a 2004 Callaway Big Bertha 7-iron?

The 2004 Callaway Big Bertha 7-iron is 33 degrees, with a 62.5 degree lie and a 37 inch standard steel length.

What changed between the 2002 and 2004 Big Bertha irons?

The 2004 set is a degree weaker at every club — a 33 degree 7-iron against 34 and a 17 degree 2-iron against 18 — and Callaway published a bounce ladder for it, running from 0 degrees at the 2-iron to 12 at the sand wedge.

What wedges came with the 2004 Callaway Big Bertha irons?

A 45 degree pitching wedge, a 50 degree W wedge (an approach wedge), a 55 degree sand wedge and a 60 degree lob wedge.

Finding a used set

The Callaway Big Bertha (2004) ran from 2004 to 2006 and is no longer in production, so the used market is the only source. Search eBay, 2nd Swing, Golf Avenue and the PGA Tour Superstore trade-in listings, and check the loft and lie against the chart above before buying — sets this age have often been bent from standard.

Data compiled from:
  • 2ndswing.com Callaway 2004 Big Bertha Iron Set specification table — loft, lie, length, bounce and steel/graphite swing weight columns for the 2-iron through lob wedge, plus the stock shaft options. The steel figures are the ones recorded here
  • qsponge.com specification table for the Callaway 2004 Big Bertha irons — agrees cell for cell on loft, lie, length, bounce and both swing weight columns
  • The Callaway Demandware ProductSpecs feed for product code irons-bb-2004 carries only the women's table for this model, so the men's numbers rest on the two agreeing secondary sources above and confidence is held at medium
  • Offset was not published for this model in the sources located, so the column is omitted rather than estimated

Last reviewed 2026-07-29. Spot an error? [email protected]