TaylorMade PSi Irons Specifications
Full factory loft, lie and length chart for the TaylorMade PSi irons, 2015–present.
- Years produced
- 2015–present
- Category
- Players Distance Irons
- Construction
- progressive set — cast long irons with a Speed Pocket, forged short irons
- Material
- forged carbon steel short irons with tungsten weighting in the 3 to 5 irons
- Set makeup
- 3–SW
Data confidence: medium. These figures are compiled from secondary sources rather than a manufacturer spec sheet. If you have an original catalogue page, send it over and we will update the chart.
Loft, lie & length chart
| Club | Loft (°) | Lie (°) | Length (in) | Offset (in) | Swing wt |
|---|---|---|---|---|---|
| 3 | 19 | 60.5 | 38.75 | 0.189 | D2 |
| 4 | 21.5 | 61 | 38.25 | 0.173 | D2 |
| 5 | 24.5 | 61.5 | 37.75 | 0.157 | D2 |
| 6 | 27.5 | 62.5 | 37.25 | 0.142 | D2 |
| 7 | 31.5 | 63 | 36.75 | 0.126 | D2 |
| 8 | 35.5 | 63.5 | 36.25 | 0.11 | D2 |
| 9 | 40.5 | 64 | 35.75 | 0.094 | D2 |
| PW | 45.5 | 64 | 35.5 | 0.079 | D3 |
| AW | 50.5 | 64 | 35.5 | 0.063 | D3 |
| SW | 55 | 64.5 | 35.25 | 0.055 | D4 |
Lofts and lies are the factory standard build. Individual clubs may differ if they have been bent, re-shafted or re-gripped during their life.
About the TaylorMade PSi
The PSi was TaylorMade's better-player iron of the M1 era, announced alongside that driver in September 2015. It runs a progressive build: tungsten weighting and a Speed Pocket in the long irons, forged heads from the 8-iron down, and face slots cut vertically into the toe and heel to keep ball speed up on mishits. Lofts are a degree and a half stronger than a traditional players set, with a 31.5-degree 7-iron, and the set runs all the way to a 55-degree sand wedge.
Stock shafts
- FST KBS Tour — steel
- Mitsubishi Kuro Kage Silver 80 — graphite
Related models
- The model it followed: TaylorMade RSi 2
- TaylorMade's next better-player iron: TaylorMade M1
- Compare: TaylorMade PSi vs TaylorMade RSi 2
- Compare: TaylorMade PSi vs TaylorMade M1
Frequently asked questions
What is the loft of a TaylorMade PSi 7-iron?
The TaylorMade PSi 7-iron has a loft of 31.5 degrees, a lie of 63.0 degrees and a length of 36.75 inches.
When were TaylorMade PSi irons made?
TaylorMade announced them on 9 September 2015 alongside the M1 driver and they reached retail on 6 November 2015.
Are TaylorMade PSi irons forged?
Only in part. The 8-iron through sand wedge are forged; the long irons are cast with tungsten weighting and a Speed Pocket in the sole.
Where it sits in the lineup
Introduced in 2015, the TaylorMade PSi is a current players distance set in the TaylorMade range, with no replacement announced. New sets are built to the standard lofts, lies and lengths in the chart above, though a fitting can move any of them — so confirm the numbers on the order sheet. Used sets appear on eBay, 2nd Swing and Golf Avenue, and should be measured against this chart before buying.
- 2nd Swing Golf specification table for the TaylorMade PSi iron set (https://www.2ndswing.com/golf-clubs/iron-sets/taylormade-psi-iron-set) — supplied every loft, lie, length, offset and swing weight above and both stock shafts.
- Note on offset: the source publishes offset in millimetres (4.8 mm down to 1.4 mm) and those figures are converted to inches here. The lie column steps by half a degree except between the 5 and 6-irons, where it jumps a full degree; that is how the source table reads and it is reproduced rather than smoothed.
- golfchannel.com 'Equipment Insider: TaylorMade announces M1 driver, PSi irons' and golfshake.com 'TaylorMade launch PSi Irons' — announced 9 September 2015 with the M1 driver, at retail 6 November 2015. Tungsten in the 3 to 5 irons, forged 8-iron through sand wedge.
- Note: bounce is omitted — the source table did not carry a bounce column. Confidence is medium.
Last reviewed 2026-07-28. Spot an error? [email protected]